Monday, November 16, 2026

Marshes and the like

At Steel Lard the other day Mark K was asking about some of the small scatter terrain pieces I had on the table.  They were some of the ones I showed here recently but I thought it might be helpful to give a step-by-step description of the process of creating them. 

The tools and materials needed are:



The bases are rafts left over from the 3D printing process. Some are irregularly shaped and those that aren't can be cut to an irregular shape with a pair of scissors. 


If you don't have access to these, something that similarly flat and thin wild. Cheap floor tiles from Poundland or the like are good, albeit a little tougher to cut.

If you're going to have pools of water to indicate a marshy area, stick on some irregular pieces of thin card. I use pieces of old business cards.


I stick them on with clear adhesive such as Uhu or Evostick. Make sure only to use tiny dots of the gun as larger amounts will cause the base to warp.

When the glue is dry the ground surface can be added using wood filler (or Tetrion, Polyfilla or similar). If you can get brown ready-coloured filler the next stage will be easier.




One or two rocks can be added for a bit of relief or in larger numbers if you want to represent areas of rocky ground. I use stones from the garden (bits of mortar are good as they often have a flat side and the texture is good) as well as bits of cat litter for smaller stones.


At this point we need a few hours for the filler to dry. After that we can paint in various shades of brown. I've taken to painting the areas around the pools in a darker brown.


The watery areas get painted black...


... and then a dry-brush with a sand colour. I usually use Vallejo Iraqi Sand but I've run out so these have Dark Sand instead.


Patches of Modpodge are painted onto the base and fine scatter is sprinkled on.


Another period of drying is now required. Modpodge dries pretty quickly; half an hour will probably do it but I tend to leave it longer.

Then we need a dropper bottle or pipette and some dilute adhesive. I've previously used WWS Layering Spray but recently ran out and got some Scenic Cement from Woodland Scenics. It seems to be more dilute but it works OK. An alternative would be to use PVA diluted with water and a drop of washing-up liquid as a flow improver. Capillary action draws the adhesive into the flock.


I then add static grass with an applicator before painting the wet areas with gloss varnish.


Add a few tufts...


...and we're done:


Drying time aside, I can make three or four of these in a hour or so. To be honest, it's quite addictive!







No comments: